WE DON'T SPRAY! WE BRUSH IT ON!
We clean and prepare the driveway by removing all the weeds and filling in the cracks with asphalt. We then blow off the dust so we can pour sealer on driveway and brush it on to protect the driveway from cracks and water damage.
This allows the driveway to look new and protected and leaves it with a nice matte black finish.
We start off by blowing the concrete off and then use a 3300 PSI power washer to clean all of the dirt, stains and grime off the concrete. Then we allow it to dry for 24 hours.
Once dry, we use Seal King concrete sealer to rejuvinate the concrete's color and to protect it from stains and cracking. Finally we use a seal grip to protect it from being slippery.
We start off by blowing the surface area off and then use a 3300 PSI power washer to remove the weeds and clean the stones. We then allow it to dry for 24 hours. Once dry, we pour polymeric sand and spread it into the cracks to fill them.
The sand is lightly soaked to get hard over night and then sealed the next day with Seal King sealer to rejuvinate and bring colour back to the stones while protecting them from sun damage and sinking.
We cut the damage area out into a square or rectangle and use ss1 glue to have the asphalt stick to the edges. We use a 1 1/2 ton roller or for small patches we use a tamper plate to compact the area.
We can do large areas as well with paving equipment when needed. We also do line painting and seal parking lots to give them a better look and to protect them from damage.
We serve all the Toronto/GTA, Peel, and Halton Regions. Thank You.